How to check tennis string tension with your phone
Yes, a phone can check your string tension. A strung racket rings like a drum when you tap it, at one main note, and the tighter the strings, the higher the note. The phone’s microphone hears that note, and from the pitch, the head size and the string, an app can work out the tension. No tension tester is needed.
Why the pitch gives the tension
A tapped string bed vibrates a few hundred times a second, and that frequency, in hertz, is the pitch you hear. Tension rises with the square of the pitch: a note 1% higher means 2% more tension.
Two other things set the note, which is why you are asked for them:
- The string. A heavier string rings lower at the same tension, so the app needs to know which string is in the racket. For a hybrid, the mains and crosses can be set separately.
- The head size. A bigger head rings lower, the way a bigger drum does.
Given the pitch and those two, the app works out the tension that would make a bed of that string and size ring at exactly that note.
How to tap the strings
- Take the dampener off. It deadens the very ring the phone listens for.
- Find a quiet room. Voices sit in the same range of pitches as a string bed.
- Lay the phone flat on a table and hold the racket by the handle, with the strings over the phone.
- Tap the middle of the string bed with something hard, like the end of a screwdriver handle. A fingertip only thuds, and a tap off-centre rings at more than one note.
- Tap a few times. A reading only counts when three taps agree, so a single bad tap cannot throw it off. If one does not match, keep tapping.

What the number means
Measured straight after stringing, a racket reads close to the tension it was strung at, the number on the stringer’s machine. Polyester reads a little lower, because it gives up more tension while the racket is being strung.
From then on the reading goes down as the strings lose tension: most of it in the first day, then mainly with play, where a few hours of hitting takes more than weeks in the bag. Stringing machines and stringers differ from each other too, so your reading and your stringer’s number will rarely match exactly. That is not a fault in either.
Watch the change, not just the number
The most useful thing a phone can tell you is how much tension your strings have lost. Measure the racket when it comes back from the stringer, then again every few sessions. Because it is the same racket, the same string and the same head, the difference between two readings depends only on the pitch, which the phone hears precisely.
When the strings start to feel dead, the readings will show how far they have dropped since they were fresh, which is a far better guide to when to restring than the date.
Where RacketCheck does the work
RacketCheck is built around this method. You pick your racket’s head size and string once, from a large built-in catalogue or by entering your own. Then you tap, and it listens, checks that the taps agree, and shows the tension in kg and lb. The sound is analysed as it arrives and never recorded.
With RacketCheck Pro, every reading is saved per racket and per string job, a graph shows the tension falling between restrings, and an alert tells you when the loss passes a percentage you choose.
Once your readings are saved, you can also read them in your stringer’s terms by calibrating a racket to the machine tension: enter the tension it was strung at, measure the fresh strings, and every later reading on that racket uses the same scale.
If your taps don’t count
- Dampener still on? Take it off.
- Tapping with a finger? Use something hard. A fingertip, or a fingernail flick, does not make the bed ring clearly enough.
- Tapping near the frame? Move to the middle of the strings.
- Noisy room? Find a quieter spot, away from talking and music.